Overview

The Unit Test Plan (UTP) will follow the same section breakdown as the Requirements in the Scope & Requirement Document [1].

The following types of tests shall be included where it makes sense.

1. In-Range UT - these are the test cases which cover normal operations.
2. Out-of-Range UT - these are the test cases which cover out of range scenarios: 
   1. border cases
   2. race conditions
   3. unexpected events
      1. EX: Tearing down an active Network Interface
3. Error UT
   1. Error parameters
   2. Error Conditions
      1. network goes down unexpectedly
      2. Wire gets disconnected, etc

Performance Testing cases will be a separate section in this document.

Unit Test Plan

Configuration tests should be done through the DLC direct interface, as well as the YAML interface.

Local Network Configuration

Expected Behavior

In-Range UT

Out-of-Range UT

Error UT

Remote Peer Configuration

Expected Behavior

In-Range UT

Out-of-Range UT

Error UT

Functional Requirements

Performance Requirements

Glossary

References